[secant0give]

Z-Foam doesn't seem to react to anything, I usually just grab a can of White Knight from bunnings and go to work.

Thanks for that Kieran, went to bunnings and some rattle cans of fast dry enamil. Masked up and sprayed about 1/2 the under side of the wings and stab yellow. Wow it too a few coats for the colour to cover that grey zfoam!! I ended up with 4 coats on it. I guess its not easy for yellow to go over a darker colour, it's certainly a big improvement now and it will still look pretty scale sitting on the ground.

That's what I was planning to do pretty much
I want to change the colour scheme as kieren suggested
What is the best paint for this kind of foam?

What was the best 2 blade prop for the stock set up?
Did you ever try a 12 x6 Steve ?

My modum seems to have died so I'm down to the iPhone

Jason i have flown the Stock Setup with 11 x 8 and with 11 x 10 and this is the current configuration 11 x 10 i have been using for ages and its been good, i'm looking forward to seeing how it will go with 3 blade 11x7 goes otherwise i will go back to the 11 x 10 prop.

I'm Not Sure how you will go with 12 x6 as it will be very low to ground possibly hit the grass ? even a 11 inch prop may be too big.

Remember mines a tail Dragger with retracts and a bigger prop is fine.

Steve

Thanks Steve,........ Arrrgh yes.......... there would be a lot more clearence with it being a tail drager. I have put taller skinny wheels on mine I will have a little more ground clearence I can allways poke the nose wheel out a bit further if I grind another flat on the strut for locking screw.

I put some filiment tape over the hinges, they looked like they might let go after a while and the tape over the servo leads on the underside of the wing was not stuck down all that well so I replaced that while I was at it. I'm still looking at some added way to secure the hatch. Other than that, It's all bound, set up and ready to go for the weekend.