05-10-2009, 08:14 PM
The mill I have is this one:
https://www.machineryhouse.com.au/Produ ... kCode=M150
I believe there is a cheaper one from the same manufacturer but its a bit of a toy. This one is light enough to be put away by one person. I did buy a good quality machine vice which is usually left on the x-y table.
The quality on this is resonable and it will still be working after I'm not, guess it depends how you value the cost, buy in cost or cost over lifetime of item.
Servo
https://www.machineryhouse.com.au/Produ ... kCode=M150
I believe there is a cheaper one from the same manufacturer but its a bit of a toy. This one is light enough to be put away by one person. I did buy a good quality machine vice which is usually left on the x-y table.
The quality on this is resonable and it will still be working after I'm not, guess it depends how you value the cost, buy in cost or cost over lifetime of item.
Servo