09-07-2012, 04:49 PM
Since I didn't get to fly this weekend after reading of the much pit runway reports. And since I've received my Motor and Mount from HK for the Super Tucano. I decided to measure, drill and fit the mount and motor. I used the existing holes in the fire-wall and re-drilled the mount to fit.
Then for the Lipo I made the bottom hatch removable with a latch for access. I removed the servo trays for the push pull retracts this gave me good access to fit a 6S Lipo in place of the fuel tank. (Will build a tray to hold the Lipo, epoxy that in when I finish the build and check the CG).
Since I removed the trays I will need to use Servoless retracts.
RC lander has just made and shipped me custom 130mm Oleo legs and metal retracts to fit staight in.
Then for the Lipo I made the bottom hatch removable with a latch for access. I removed the servo trays for the push pull retracts this gave me good access to fit a 6S Lipo in place of the fuel tank. (Will build a tray to hold the Lipo, epoxy that in when I finish the build and check the CG).
Since I removed the trays I will need to use Servoless retracts.
RC lander has just made and shipped me custom 130mm Oleo legs and metal retracts to fit staight in.
George
"Crash and Cry! Don't fly"
RadioX9 & DX8
HK Cri Cri ugly,Super Cub 1870mm balsa, Sbach 1000mm balsa, Vampire, Katana E50 balsa, BA Hawke 90mm (on hold for large runway), Durafly BF110, Corsair,
EScale Zero
Freewing Eurofighter Typhoon & SU-34
Starmax F5e Tiger & 70mm F-18
FMS T-28 Trojan, P-38 Silver, 50mm F-86, C-17 Globmaster
Fly fly F-100
B-25 2.0m LX and A10 1.5m Langxiang (being glassed and re-built)
Seagull Super Tucano