09-12-2009, 08:34 PM
Hi Drew
Here is a link for the depron.
http://www.depron-australia.com
Glue here:
http://www.hobbyking.com/hobbyking/stor ... ue_(Medium)
I would use 6mm for out door, 3mm for indoor.
$130 would get you 10 medium sized models at 20 sheets.
I was thinking of some grey and building one of these.
http://rc.tomhe.net
Don't worry about dxf or mill cutting it takes too much time.
Just scale the pdf, then print to A4.tape up sheets and cut with a sharp knife
Srl
Here is a link for the depron.
http://www.depron-australia.com
Glue here:
http://www.hobbyking.com/hobbyking/stor ... ue_(Medium)
I would use 6mm for out door, 3mm for indoor.
$130 would get you 10 medium sized models at 20 sheets.
I was thinking of some grey and building one of these.
http://rc.tomhe.net
Don't worry about dxf or mill cutting it takes too much time.
Just scale the pdf, then print to A4.tape up sheets and cut with a sharp knife
Srl