Who's got a Dremel? -
Skidz - 05-04-2011
Hi fellow clubbers,
Has anyone got a Dremel tool? I bought a new Scorpion motor for the new heli and the shaft is about 10mm too long. Missed a critical dimension.
Shaft is 6mm dia so perhaps a bit bigger than normal. Need to cut it off neatly. If I don't, then beside looking odd, it could stab my lipo and cause serious mid-air issues... and I don't want that!
Dave
RE: Who's got a Dremel? -
secant0give - 05-04-2011
G'day Dave,
I've got one but it might be nicer to part it off on a lathe If you want to bring it along to the field next I'll shorten it for you neatly.
Jason
RE: Who's got a Dremel? -
Skidz - 05-04-2011
(05-04-2011, 06:55 PM)secant0give Wrote: G'day Dave,
I've got one but it might be nicer to part it off on a lathe If you want to bring it along to the field next I'll shorten it for you neatly.
Jason
Yes, a lathe would be the best. I'll bring it down Sat and show you the issue.
Dave
RE: Who's got a Dremel? -
gbanger - 05-04-2011
Hey Dave
Ive got a HK dremel and its a little ripper.
If you want to drop round tomorrow afternoon we can get the surgery sorted.
Gazz
RE: Who's got a Dremel? -
Skidz - 05-04-2011
(05-04-2011, 08:20 PM)gbanger Wrote: Hey Dave
Ive got a HK dremel and its a little ripper.
If you want to drop round tomorrow afternoon we can get the surgery sorted.
Gazz
Ok. Since you live so far away (150m) I think we could give it a whirl. failing that, Jason has access (or has) a lathe. What time? Gotta pick the girls up from netball training around 7.30. After that ok?
RE: Who's got a Dremel? -
gbanger - 05-04-2011
No problems mate.
What ever time suits you.
I will give you a ring tomorrow afternoon.
RE: Who's got a Dremel? -
Skidz - 06-04-2011
(05-04-2011, 11:30 PM)gbanger Wrote: No problems mate.
What ever time suits you.
I will give you a ring tomorrow afternoon.
Gazz, might hold the surgery for the moment. I have ordered a counterbearing from Readyheli in USA (not stocked locally). This gives a strong assembly and needs the longer shaft. Might trim the shaft later when I know exactly how much is needed.