[secant0give]

Thanks for compliments guys, but to be honest this is not anything more than very simple wood work and metal work. It's not beyond the ability of anyone who is willing to pick up some basic hand tools and have a go at it.

I'm hoping to show just one way of makeing a set of hot wire cut foam cores. I found this method the easiest way to make a nice wing section. If their done carefully wings can made be very light and strong as well quite accurate. Truthfully it's not a difficult technique at all if you follow the steps carefully. My philosophy in building anything is "do it by the simplest, fastest, most efficient method that will give the required quality". If I do this I often find there will be time and funding left over to make more !!

I'm taking photo's and posting this part of the build in the hope that someone will see it and say, "Oh that's how it's done, that doesn't look too hard, I'll give that a go." Or something "like That looks a little better than the way I've done it in the past." Or the ultimate would be "Jase I can show you an easier, even better, lighter, way to do this"