28-01-2013, 10:49 PM
I usually zap the wire into the crimped tubes for a little extra secutity. I've never had one one loose. The wires need a bit of tension. you should only feel the backlash of the servo when you move the rudder. It shouldn't flop around. One thing to check is that it's not tight around the center and gets looser as you move the rudder over to each side. If it does this you need to move the holes in the controll horn off the center line by the same ammount as the holes on the rudder are from the centerline of the hinge. then it will work spot on. I've had this little adventure once before.
Did they give you a controoll horn extention for the rudder with the Kit ??
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci