24-01-2013, 12:26 AM
^^^^^ yes thats right . the horizontal stabilizer was a bastard to fit , because it requires lots of epoxy , i did mine with 5 minute epoxy because of this i had a lot of blobbing , if i could do it again i would use 20min epoxy, because it is a loose fit you have to make sure it doesnt move while setting . i jinxed mine bye eye , however the loose fit allows the glue to run between surfaces for good adherence .
i recommend fit the wings 1st and use them as an alignment reference when fitting stabaliser . this isnt in the instructions as far as i recall , and because its a rather large model allow gluing to dry over night .
WAYNE ? IM CONFUSED ? those servos you ordered are they 47g or 79g each ?
i recommend fit the wings 1st and use them as an alignment reference when fitting stabaliser . this isnt in the instructions as far as i recall , and because its a rather large model allow gluing to dry over night .
WAYNE ? IM CONFUSED ? those servos you ordered are they 47g or 79g each ?
patience !! paaatience !! paaaaaatience paaaaaaatieeence dooooohhhh !!!
DANGER WIFE CAN READ FORUMS . love you darling . sig changed .