[samste]

I bought this on impulse when in came in on the New Items Section On hobbyking,


http://www.hobbyking.com/hobbyking/store..._PNF_.html


Not what i was Expecting as i originally just wanted to put togeter as built PNF and Do Just That.

Very Disappointed in the Build Supplied Pnf,
Motor mount was flimsy, Main Wing Original Fixing Mount basically Snapped off giving it the pull apart test once secured.
Internal Motor gave it a Yank and front motor mount Cracked.
Motor Shaft was Bent as well, Cog Was Impossible to get at that config setup without weight to Tail.

Hence i gave it a little work over and keeping the same weight, swapped out motor, New ESc Installed towards back of Plane to center cog better with a lighter motor helping out as well, redid main wing mount alloy plate and nut and bolt.
Servo Rods replaced and rehinged badly designed. Elevator plastic hinges as it was very flimsy

Lets now see how it Flies, as i not going to spend anymore time on it as I prefer to do my GL Speedy Mod Build again with my spare ready to go with added strengthening to stop the wings from spreading apart and snapping at high G's.

Photos completed less servo protectors/ drag reducer, as they dont fit either,
3s Setup Approx 500 Watts 7x6 , 50 amps , motor comes down cool full throttle constant.
4s setup 1013 Watts 7x6 Prop, 80 amps , motor bursting only on full throttle, warm to hot. (caution with throttle control as motor can get super hot and burn out)
Ntm prop drive28-36 1800kv will run constant on 4s 7x6 prop but less top speed.
Need To experiment with Props as im after Torque Speed not Top Speed, Hence 7 Inch but 6 Inch may work Well,
Though Its Low Noise Rc With 7 Inch Prop which is Good as 5x5 etc brings out the high Pitch Noise.