[samste]

Just a Quick Post
Re - Esc Used in My Stryker 90mm Edf Setup

http://www.hobbyking.com/hobbyking/store...s_ESC.html
   

The Turnigy K-Force series are based on an all new powerful microprocessor.
The new CPU means ultra fast sync timing, crisper throttle response, less battery load and reduced FET heat buildup.

Specification:
Output: Continuous 100A, burst 150A up to 10 seconds.
Input Voltage: 2-6 cells lithium battery or 5-18 cells NIMH battery.
BEC: Switching mode DC-DC regulator. 3A@5.25V or 3A@6V switchable by user progromming.
Control Signal Transmission: Optically coupled system.
Max Speed:
2 Pole: 210,000rpm
6 Pole: 70,000rpm
12 Pole: 35,000rpm
Size: 70mm (L) * 34mm (W) * 16mm (H).
Weight: 82g.

Features:
*High performance microprocessor (24khz) brings out the best compatibility with all kinds of motors and the highest driving efficiency.
*Wide-open heatsink design to get the best heat dissipation effect.
*Improved Normal, Soft, Very-Soft start modes, compatible with aircraft and helicopter.
*Smooth, linear, quick and precise throttle response.
*Throttle signal transfered through optically coupled system to avoid the electromagnetic interference.
*Multiple protection features: Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection
*Governor mode for helicopter.
*The firmware of the ESC can be updated through the USB adapter.
*User programmable via Tx, Programming card or pc USB port. .

*Not compatible with non K-Force esc programming card.


Gazz i hoping it's only a Timing and Heat Issue with the Turnigy Dlux
http://www.hobbyking.com/hobbyking/store...gging.html

You May find that it needs the Frequency Switching up from the default 8khz to 16khz, as mine is Running at 24khz and is smooth as and cool as it is switching at a comfortable rate for the kv, motor Pole and lipo setup.
Turnigy Plush 80amp which i have used on this setup a few times worked fine but being 80 amp and running on its limit i upped it to the kforce 100amp but i cannot find its switching freq as its not spec on item
http://www.hobbyking.com/hobbyking/store...oller.html

Steve

EDIT DLUX ESC STATES ONLY 2 POLE MOTOR RPM NO SPECS FOR OTHER POLES THIS COULD BE THE ISSUE ?