30-04-2012, 08:18 PM
Just a Quick Note -
RE - STRYKER Q, USING LAUNCHING PAD FOR TAKE OFF
Stock Stryker Q does not have enough Thrust to Launch From Ramp.
Modifiocation Required is Below -
Setup 1 - 1450kv 3536 motor $15-00 from leader hobby
http://www.leaderhobby.com/product.asp?ID=9394001100052
Prop Required is 8x6 Electric Apc
Setup 2 - 1800kv 3536 Turnigy $18-00 from hobbyking
http://www.hobbyking.com/hobbyking/store...duct=15169
Prop Required is 7x6 electrica Apc
I'm Using Setup 1, not as fast as Setup 2.
Setup 2 is being used by the Master of Strykers Kizza
Hope This Helps People if you had Difficulties in launching off Ramp.
Plus these Setups will reduce the Noise Output to Below 80db, Mine has been tested and approved at Pemac, i Think Kierans has Too.
Steve
RE - STRYKER Q, USING LAUNCHING PAD FOR TAKE OFF
Stock Stryker Q does not have enough Thrust to Launch From Ramp.
Modifiocation Required is Below -
Setup 1 - 1450kv 3536 motor $15-00 from leader hobby
http://www.leaderhobby.com/product.asp?ID=9394001100052
Prop Required is 8x6 Electric Apc
Setup 2 - 1800kv 3536 Turnigy $18-00 from hobbyking
http://www.hobbyking.com/hobbyking/store...duct=15169
Prop Required is 7x6 electrica Apc
I'm Using Setup 1, not as fast as Setup 2.
Setup 2 is being used by the Master of Strykers Kizza
Hope This Helps People if you had Difficulties in launching off Ramp.
Plus these Setups will reduce the Noise Output to Below 80db, Mine has been tested and approved at Pemac, i Think Kierans has Too.
Steve
What Do You Mean Theres a Throttle Curve ?, Its Either all the way up or all the way down