13-03-2011, 10:59 PM
Hi all,
Has anyone had any experience with programming of digital servo's?
I need to reverse the direction of travel with a given input signal from the RX.
The plane I am building uses 2 servo's for the elevator and you can reverse 2 wires in the Y lead or programe a servo to run in reverse.
The servo in question is a Corona/HobbyKing DS 929MG
Thanks
Chris
Has anyone had any experience with programming of digital servo's?
I need to reverse the direction of travel with a given input signal from the RX.
The plane I am building uses 2 servo's for the elevator and you can reverse 2 wires in the Y lead or programe a servo to run in reverse.
The servo in question is a Corona/HobbyKing DS 929MG
Thanks
Chris