23-08-2013, 07:00 AM
Yep Gazz is right either 3/8 or 10mm Aluminum machine bar or T6061 will do. 7000 series Aluninum bar is OK too you just don't want the soft gooey stuff that doesn't machine well. Machine bar is the best for this job tho'.
You can get it from Smart Aluminum in Eirskin park, you'll get a 4m length for less than $10 I reckon.
Erskine Park
Building C1, 1-107 Erskine Park Road
ERSKINE PARK NSW 2759
Tel + 61 2 9670 8500
Fax +61 2 9670 8555
You can get it from Smart Aluminum in Eirskin park, you'll get a 4m length for less than $10 I reckon.
Erskine Park
Building C1, 1-107 Erskine Park Road
ERSKINE PARK NSW 2759
Tel + 61 2 9670 8500
Fax +61 2 9670 8555
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci