26-02-2013, 10:33 PM
Questions about glues and depron.....
I am looking at starting my extra - my original plan called for foam safe CA for joins, but reading up on here I also see mentions for hot melt glue and for UHU. I would prefer its a lighter build, which from what I have read seems to suggest CA. Is this correct?
Also, for cut depron should I be sealing this stuff prior to flight? Some of the surfaces feel abrasive, and like they will lose pieces just from rubbing. Is it an idea to paint it up to provide some protection against that, even if its a clear coat?
I am looking at starting my extra - my original plan called for foam safe CA for joins, but reading up on here I also see mentions for hot melt glue and for UHU. I would prefer its a lighter build, which from what I have read seems to suggest CA. Is this correct?
Also, for cut depron should I be sealing this stuff prior to flight? Some of the surfaces feel abrasive, and like they will lose pieces just from rubbing. Is it an idea to paint it up to provide some protection against that, even if its a clear coat?
Radio: DX8, Mode 1
Blu-Baby (decided to go green and hug a tree, in repairs)
Parkzone T-28 Trojan (pilot looks asleep but plane ready to go)
E-Flite UMX Beast (Barrel roll you say? But I did 10 in a row while you were asking)
Parkzone T-28 Trojan Ultra-Micro (terrorising the local workplace in the name of more practice)
Parkzone Stryker Ultra-Micro (ready to take fingers off willing launchers)