[wingtipper]

it has rotating retracts , a very quiet scale sounding 4 blade prop , low rpm 500KV ON 4S .
the cg was about 97 mm with the battery right up the front . i added 2 strips of lead about 70mmx10mmx 1mm each , directly behind the prop inside the cowel .
it has been fully assembled without glue , IT SCREWS TOGETHER . i just put a little hotment on the cowel to keep it on , and on all the wiring just to secure it ( 2 drops) .
its quite sturdy . it is all set up and ready to go . on 4s pulls 45amps 600 watts .
I ADDED A FEW DECALS . i love it .
still deciding wether to pull it apart and add a little glue for structural strength , the kit comes with the rubber glue in a tube , but the instructions dont suggest you use glue anywhere , i am very impressed with the quality of the build , nothing needed redoing at all and everything fitted at factory was tight and right .

it has the req 90mm CG now , and should run for around 7 minutes on 2600mah 4s
i build slow and take time , this thing was ready in 4 hours .
i may maiden the PANTHER and the CORSAIR tomorrow if the weather permits .
the corsair is placed between two chairs and parked where my car normally sits in the garage , still havent worked out where or how to hang it .