01-12-2011, 01:50 PM
Ok i finally got my lipos for my viperjet build and did a test run to make sure all is good before i continue on with my viperjet project.
As Power is most importantant
It got quite windy in the office doing the test, just spent 10 minutes picking up all the papers that flew everywhere.
Test Results
7s lipo setup, 70 amps, 1750 watts,
I think plenty of thrust coming out so its been as rob says ?
My other thoughts was to rod connect the elevator either side and then one rod back to servo, and yes i think the 939 or 929 metal gear will be fine.
Steve
As Power is most importantant
It got quite windy in the office doing the test, just spent 10 minutes picking up all the papers that flew everywhere.
Test Results
7s lipo setup, 70 amps, 1750 watts,
I think plenty of thrust coming out so its been as rob says ?
My other thoughts was to rod connect the elevator either side and then one rod back to servo, and yes i think the 939 or 929 metal gear will be fine.
Steve
What Do You Mean Theres a Throttle Curve ?, Its Either all the way up or all the way down