12-09-2021, 07:20 PM
Carlou, your conversion is looking good. That 9mm thread looks like it could be 9x0.5mm but that will need to be measured correctly.
Will aluminium be fine to put up with the torque from the motor? Or do you think brass might be the go? Plus the rotation of the motor, will that be clockwise looking from the base of the motor so that it will always be tightening the thread and not loosening?
Will aluminium be fine to put up with the torque from the motor? Or do you think brass might be the go? Plus the rotation of the motor, will that be clockwise looking from the base of the motor so that it will always be tightening the thread and not loosening?
Gravity sucks, or should I say, is the downfall of all things flying. It's the way it's controlled that makes the end memorable or not.