08-03-2016, 11:34 AM
James,
With FRsky receivers, basically the failsafe function is contained with in the receiver.
It doesn't matter of your using another radio with an FRsky module.
You simply turn both TX & RX on place the sticks where you want them and momentarily push the button on the RX.
Ideally you'd set throttle to zero and a slight bit of up elevator for a fixed wing.
If you have a quad with RTL mode you set the switch that initiates RTL for failsafe. or you might set alt hold mode or a throttle setting just below hover.
Bear in mind that fail safe might only be temporary and control might be restored after some short but worrisome interval. I've seen this happen.
With FRsky receivers, basically the failsafe function is contained with in the receiver.
It doesn't matter of your using another radio with an FRsky module.
You simply turn both TX & RX on place the sticks where you want them and momentarily push the button on the RX.
Ideally you'd set throttle to zero and a slight bit of up elevator for a fixed wing.
If you have a quad with RTL mode you set the switch that initiates RTL for failsafe. or you might set alt hold mode or a throttle setting just below hover.
Bear in mind that fail safe might only be temporary and control might be restored after some short but worrisome interval. I've seen this happen.
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci