11-07-2016, 07:50 PM
We have a few eachine 250 quads in the club... I can think of myself, Dirk, Bob and Simon. Have any of you migrated it to Cleanflight. Seems there are a few steps, and while I can find instructions on the net, I am just a bit concerned to stuff it and brick the board, was hoping someone has going before me.
Here is where i am getting concerned... I am using libre and it says the fw is custom or not certified, (i think eachine have a custom factory fw for their cc3d boards, that might be a concern there).
To update I have to put v1.1 of cleanflight cc3d fw on. But to do that I need an old version of openpilot, which is 32bit, no I dont have a 32bit computer anymore... I can install and run OP but without 64bit drivers I risk at best not being able to update at all, at worse corrupting the board.
If I get the fw on, I assume then CF will allow me to update to latest fw through an update process ? (hadnt looked that far)
So anyone tried this or am I going to be the test bunny??
Here is where i am getting concerned... I am using libre and it says the fw is custom or not certified, (i think eachine have a custom factory fw for their cc3d boards, that might be a concern there).
To update I have to put v1.1 of cleanflight cc3d fw on. But to do that I need an old version of openpilot, which is 32bit, no I dont have a 32bit computer anymore... I can install and run OP but without 64bit drivers I risk at best not being able to update at all, at worse corrupting the board.
If I get the fw on, I assume then CF will allow me to update to latest fw through an update process ? (hadnt looked that far)
So anyone tried this or am I going to be the test bunny??