19-09-2013, 07:21 PM
Cutting & threading probably not an option, threads are rolled formed. Unthreaded section is a smaller diameter than thread.
I have emailed Craig who has contacts with Super n Cheaper who might be able to get them rectified. Otherwise may have to source 3mm rod & thread both ends.
Last time I was at Hobs in the Hills, they only had 2.5mm threaded rods. If I can source 3mm threaded rod as I would like to use supplied ball joints & control horn connectors.
Oh the joys of ARF
I have emailed Craig who has contacts with Super n Cheaper who might be able to get them rectified. Otherwise may have to source 3mm rod & thread both ends.
Last time I was at Hobs in the Hills, they only had 2.5mm threaded rods. If I can source 3mm threaded rod as I would like to use supplied ball joints & control horn connectors.
Oh the joys of ARF