19-09-2023, 02:47 PM
The betafpv rx has 5 sets of pwm pins.
I have not used the betafpv rx with 2 aileron channels (I used a y-lead). However Florian is using this rx on his superextra with 2 ailerons plugged into the rx.
The number of sets of pwm pins is not the number of elrs channels, I set the number of channels to 8. When I run the elrs lua, I get packet rate 100 Hz full, telem ratio 1:32, switch mode 8ch, model match off.
In the mixer you leave ch 5 empty, and set one aileron to ch 6. This ch6 aileron then plugs into the 5th set of pins.
As a general rule, leave ch 5 empty in the mixer. It is the elrs arming channel, and arming is best managed with the same switch you use for throttle cut/throttle armed, using a special function entry.
I have not used the betafpv rx with 2 aileron channels (I used a y-lead). However Florian is using this rx on his superextra with 2 ailerons plugged into the rx.
The number of sets of pwm pins is not the number of elrs channels, I set the number of channels to 8. When I run the elrs lua, I get packet rate 100 Hz full, telem ratio 1:32, switch mode 8ch, model match off.
In the mixer you leave ch 5 empty, and set one aileron to ch 6. This ch6 aileron then plugs into the 5th set of pins.
As a general rule, leave ch 5 empty in the mixer. It is the elrs arming channel, and arming is best managed with the same switch you use for throttle cut/throttle armed, using a special function entry.