24-10-2011, 09:52 PM
Guys I need some advice, when I was just setting up my funcub with new Futaba T6ex radio gear I came to putting in the 4 x Hitec HS-55 Feather servos into the wings one at a time without wire extensions or anything, a couple of them worked but chattered and buzzed a bit to the point I was concerned. One now doesn't work, the others seem like if I work them they slow up so I've stopped testing. I've got the next size Hitec servos fitted up for rud/elev and they are working no dramas. I've also run some of my old JR servos and they work well with no buzzing etc. I'm using a 6 volt receiving pack supplied just to set it up. On the side of the servo box it says between 4.8 - 6 volt operation. I can't see that its been hooked up wrong. Any help on this topic would be great. thanks Andrew.