18-09-2013, 01:43 AM
Have just started my build of this monster.
1st task was hinging the ailerons - no problems.
2nd - instal the aileron servos, push rods & control horns.
Supplied pushrods are 110mm long & I estimate to be 50mm too long (control horn screw hole would be 10mm past the 1/2 way mark of the aileron towards the trailing edge). Are threaded both ends and cant be shortened, I dont possess die sets to shorten & rethread them. I presume Gazz's & Franks are Super & Cheaper models, did both of you have this problem or am I just the unlucky one. If you experienced the same problem, how did you sort the problem. Assistance will be appreciated with thanks.
1st task was hinging the ailerons - no problems.
2nd - instal the aileron servos, push rods & control horns.
Supplied pushrods are 110mm long & I estimate to be 50mm too long (control horn screw hole would be 10mm past the 1/2 way mark of the aileron towards the trailing edge). Are threaded both ends and cant be shortened, I dont possess die sets to shorten & rethread them. I presume Gazz's & Franks are Super & Cheaper models, did both of you have this problem or am I just the unlucky one. If you experienced the same problem, how did you sort the problem. Assistance will be appreciated with thanks.