17-03-2013, 05:03 PM
I might look at that motor, get the extra grunt out of the motor... or would brushless be any better? there is probably a thread on here somewhere for that.
What size main drive gear are you using?
I think I'm going to get the http://hobbyking.com/hobbyking/store/uh_...duct=25191
it is also belt drive so I figure i'm safe enough.
I have some tools, but was looking at getting more of them, as well as the pitch gauge.
Loctite and that sort of thing I have at work, so i'll grab a bottle from there.... sadly we don't sell the smaller tools, otherwise i could get a really cheap set out of work again also...
When it comes to the build, is the assembley just putting screws in pre drilled holes, or at least well marked holes? Or is there going to be a bit of measuring and stuff and then putting the screws in?
What size main drive gear are you using?
I think I'm going to get the http://hobbyking.com/hobbyking/store/uh_...duct=25191
it is also belt drive so I figure i'm safe enough.
I have some tools, but was looking at getting more of them, as well as the pitch gauge.
Loctite and that sort of thing I have at work, so i'll grab a bottle from there.... sadly we don't sell the smaller tools, otherwise i could get a really cheap set out of work again also...
When it comes to the build, is the assembley just putting screws in pre drilled holes, or at least well marked holes? Or is there going to be a bit of measuring and stuff and then putting the screws in?
Eflite Apprentice 15A
HK450 pro
Spektrum DX8