21-06-2013, 05:51 PM
Once the moulds are all done its not that time consuming to do
Should be able to make a fuse moulding and wing in fairly short order and it will be up to the builder to cut out the tail group and do most of the fitting
It won't be bind and fly
And I'm not doing it to make money.
If you buy one you have to make a commitement to come along and race it that's the bottom line it's just that simple
Should be able to make a fuse moulding and wing in fairly short order and it will be up to the builder to cut out the tail group and do most of the fitting
It won't be bind and fly
And I'm not doing it to make money.
If you buy one you have to make a commitement to come along and race it that's the bottom line it's just that simple
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci