04-02-2013, 09:14 PM
yes mate i did put an air hole in the fuse under the horizontal stab, there is a servo hole opposite the elevon servo . i just cut the film there exposing it .
regarding your speedie , 2 things . they are meant to go inside the cowel , for max airflow and cooling , to do what you did , you wouldve had to extend wires from the motor , i'm not sure if that has electrical consiquences with heat and load .
your setup even on 5 s will be pulling over 70 amps with ease , that creates a lot of heat , if your speedie gets too hot it will fail or go into thermo safety and cut power , i'm not sure you've done the right thing there mate .
regarding your speedie , 2 things . they are meant to go inside the cowel , for max airflow and cooling , to do what you did , you wouldve had to extend wires from the motor , i'm not sure if that has electrical consiquences with heat and load .
your setup even on 5 s will be pulling over 70 amps with ease , that creates a lot of heat , if your speedie gets too hot it will fail or go into thermo safety and cut power , i'm not sure you've done the right thing there mate .
patience !! paaatience !! paaaaaatience paaaaaaatieeence dooooohhhh !!!
DANGER WIFE CAN READ FORUMS . love you darling . sig changed .