24-09-2010, 10:35 AM
What Kev suggests is the way to go.
However, if you still find it impossible to remove the bubble
completely try just pricking the bubble with the point of a needle
and then apply some heat.
I used to use that method many years ago when I was building balsa models
However, if you still find it impossible to remove the bubble
completely try just pricking the bubble with the point of a needle
and then apply some heat.
I used to use that method many years ago when I was building balsa models
Jet Teng L39(Breitling)
Scratchbuilt F14 Tomcat(Pukin Dogs)
Vector X
Eflite F86 Sabre(Taz Tiger)
Qantas Airbus A380(Nancy-Bird Walton)
Boeing 737-800
ProEDF F16
Falcon 120(Gas Turbine)
Fly Fly F100 Super Sabre
Pheonix Tiger 6
VQ Models P61 Night Fighter
CY Models FW190