29-04-2011, 07:13 PM
Well said Kev.
Check the load on the rods with the servos horns removed but pulling through the same plane (and I dont mean your plane, I mean the position they would be in if connected to the servos), if they move with little to no effort then it will be as Kev says, just servo sensitivity. If they are sticky and require some effort to move them, then you may need to re route them, BUT on an Eflite ARF I doubt that vey much.
Gazz
Check the load on the rods with the servos horns removed but pulling through the same plane (and I dont mean your plane, I mean the position they would be in if connected to the servos), if they move with little to no effort then it will be as Kev says, just servo sensitivity. If they are sticky and require some effort to move them, then you may need to re route them, BUT on an Eflite ARF I doubt that vey much.
Gazz
Parkzone Stryker 27 Evolution
E flite Ultra Stick , T 28 Carbon Z
Skyartec Skyfun Scorpion,Skyfun 90 EDF
Hobbyking Voltigeur, Funfighter T28, Mirage 2000, Minimoa 2.4m Glider
Jet Teng L-39 HPAT Stumax 90
Pheonix Tiger 50
FliteWork Extra 300 LPX 2.6M
Spectrum DX9i , DX6
Don't ever let the fear of landing keep you from taking off!