29-08-2011, 10:11 AM
(28-08-2011, 08:59 PM)kizza42 Wrote: It would be awesome and I would have preferred pitch vectoring, It would probably be easier to setup from scratch than modify this to do it though.
I don't think it would be hard to do at all. perhaps you just need a motor mount attached to a ball joint or a decent duty rod end like this one
http://australia.rs-online.com/web/p/rod...s/7124986/
Then two reasonablly powerfull metal gear servos one to move it in pitch and the other for yaw.
Perhaps you might even get it to fly 3d
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci