01-12-2011, 09:02 PM
Thanks Guys for the Tips
done the wing servos flaps and elevons, elevons ar a issue with the 939 h/k servo as they are width wise about 2mm too big, but with some balsa squashing and servo housing trimming to one side fixed this.
Yes putting in retracts, why ? i don't know.
Edit RETRACT FITTING
Ok after all that debating on retracts and i have two different sets, one that is a light set 80gms total and then my heavier set 200gms will not fit in its location as you only have 12mm height clearance, and both my retracts sets length are too long as well.
So will stick too fixed landing gear for maidening of viper and if worthy of Retracts will custom fit a slim set of retracts later.
done the wing servos flaps and elevons, elevons ar a issue with the 939 h/k servo as they are width wise about 2mm too big, but with some balsa squashing and servo housing trimming to one side fixed this.
Yes putting in retracts, why ? i don't know.
Edit RETRACT FITTING
Ok after all that debating on retracts and i have two different sets, one that is a light set 80gms total and then my heavier set 200gms will not fit in its location as you only have 12mm height clearance, and both my retracts sets length are too long as well.
So will stick too fixed landing gear for maidening of viper and if worthy of Retracts will custom fit a slim set of retracts later.
What Do You Mean Theres a Throttle Curve ?, Its Either all the way up or all the way down
