19-03-2011, 08:05 PM
(19-03-2011, 02:53 PM)chrism Wrote: Hi Drew/Andrew,
Thanks guys for the info. I must say that I am a little disappointed that digital servos can not be reversed by rewiring, this means that I will probably have to source the reversing lead - damm it.
As far as programming the servo goes I have seen snipitts on the web about this and I spoke to LHS (Ultimate) on it also. The LHS said that very high end servos can be reprogrammed but they felt that at lower end that can not. So what does it mean when the product is called a Programmable Digital Servo?
Has anyone had any experience in this area & does anyone have a programming device/interface?
The servo that I need to reverse is as below
http://www.hobbyking.com/hobbyking/store...oduct=6314
Cheers
Chris M
The Hitec HS 5085 MG can be programmed acording to the instructions that come with it, I've not tried it tho'
You can get them from here for about $30 each including postage
http://www.dealextreme.com/p/hitec-hs-50...rque-20096
They are a pretty good servo lots of torque for their size and metal gears, they are reasonably fast as well
Did I also mention that they are LIGHT and small too
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci