[dfw]

My Elrs experience thus far:

Radiomaster TX16 mark II
Matek ELRS-R24-P6 ExpressLRS 2.4G PWM Receiver With Antenna Support 2~8S VBat Voltage Sense

Upgrading firmware via Wifi is pretty straight forward.
Edge TX software updates straight from your browser.

I had an issue with the Matek RX not binding automatically to TX, even after quadriple checking the binding phrase.

I used the Matek specific model no to compile the code for the RX. Matek's website does instruct you to use the Generic source for this receiver.
After recompiling / reflashing with the generic code (Version 3.3.0), binding works perfectly fine. so Check the recomended firmware source from the RX manufacturer, it might be different from the actual model number listed !

Once that was out of the way, setting up EdgeTX for basic configurations takes some playingd around, but once you get into it, it's actually pretty straight forward and very flexible to setup.