Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

HELP - Building a Reactor Electrify plane
#2

Does anybody agree with the Recommended control surface throws on Low and High rates?

I agree with the settings of High Rate and 3D but very sceptical to have a 1 inch Up/Down throw on Aileron at low rates. If you take off, land and do the forward flights at low rate, wouldn't be a 1-inch throw on the aileron be very twitchy? Any reaction will be appreciated.

   

Here's how big is the Aileron measured at the center. So 1 inch up and down throw I think will make the plane twitchy.
   
Reply


Messages In This Thread
HELP - Building a Reactor Electrify plane - by carlou - 10-11-2021, 05:30 PM
RE: HELP - Building a Reactor Electrify plane - by carlou - 11-11-2021, 05:01 PM
RE: HELP - Building a Reactor Electrify plane - by srl - 12-11-2021, 10:38 AM
RE: HELP - Building a Reactor Electrify plane - by Quadzimodo - 12-11-2021, 06:36 PM
RE: HELP - Building a Reactor Electrify plane - by carlou - 13-11-2021, 07:16 AM
RE: HELP - Building a Reactor Electrify plane - by Quadzimodo - 13-11-2021, 02:00 PM
RE: HELP - Building a Reactor Electrify plane - by carlou - 16-11-2021, 09:44 AM
RE: HELP - Building a Reactor Electrify plane - by Quadzimodo - 16-11-2021, 06:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)