[symowallo]

I managed to get my Eachine 250 cc3d board to load CleanFLight firmware.

I first used an older Cleanflight version .bin file to reprogram the board to Cleanflight,
(hoping it would then allow me to update to 1.13 -Fat Hope- )
Ended up using Cleanflight firmware upgrade and an FTDI like serial programmer to load the latest cleanflight .hex (1.13)

It's working to the point were the serial receiver is responding (Lemon satellite in Uart 1)
Still need to work out the other settings (PID, Motor mapping etc )

Would anyone have a cleanflight base setting for the eachine 250 ?

Cheers,
Dirk.

Go with Betaflight on stock settings. The stock settings are more than flyable. You flash Betaflight the same way as Cleanflight. It is tuned much better out of the box than Cleanflight, but is based off the same codebase.

This is the easiest to follow guide: http://www.phasercomputers.com.au/2016/0...ete-guide/