[BOB]

Hi Rob. I had a real good look at the harness this morning what has happened around the wire harness through where gap at the top of the frame and down to where it plugs in to the CC3D board and apparently it rubbed up again the FPV transmitter as well is been hot there is a very sharp edge so that’s what happened exactly.

Now fixing the problem once and for all I got a by a new hot glue gun as the one have is had it so once I get the new one as Simon suggested I put a little bit of glue on the terminal and I am Garner in case the harness and a little bit of shrink tubing one question this shrink tubing is fairly large and if I use hair dryer to shrink the tubing will damage the cable?, All just have to go very carefully I suspect.

Now Rob and dirk who have also got Eachine?. Make sure you do not fall into the same trap I did or so can contact banggood via email to see if they’ve got any wire harnesses.