09-07-2015, 11:22 PM
Hi Bob My SK450 runs 4 20A Afro esc's and 850 KV motors with 11X5 props I'm using a 3S 10C 5200 Lipo pack.
From memory it's only pulling about 15-18 amps in hover that's with all the motors going. If I really nail it, it goes to about 50A but you cant do that for too long cause it climbing so hard it'll end up ridiculously high in no time at all. I really doubt it gets much over 30A when it really being pushed around without gaining height. the distribution lead looks fine and should be ample for the task tho you might be able to get a cheaper one from HK for instance http://hobbyking.com/hobbyking/store/__6...rness.html
From memory it's only pulling about 15-18 amps in hover that's with all the motors going. If I really nail it, it goes to about 50A but you cant do that for too long cause it climbing so hard it'll end up ridiculously high in no time at all. I really doubt it gets much over 30A when it really being pushed around without gaining height. the distribution lead looks fine and should be ample for the task tho you might be able to get a cheaper one from HK for instance http://hobbyking.com/hobbyking/store/__6...rness.html
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci