05-06-2014, 10:24 PM
A bit more done this evening.
The motors were removed the cling wrap went taken away leaving the motor mounts nicely bonded to the fuselage. Then any extra glue that drooled out and might rub on the motor is removed with the Dermal.
The motor goes back in and after checking to make sure it doesn't rub anywhere all the screws are put in and tightened up firmly
The next step it to carve out a little pocket for the lipo pack to sit in. I just trace around the pack then use the same wheel on the dremel to open it out so the lipo pac drops in neatly and doesn't move about. Just like in the next pic.
I finish up by putting the pack in there and making sure the lid will sit down nice and flush
The motors were removed the cling wrap went taken away leaving the motor mounts nicely bonded to the fuselage. Then any extra glue that drooled out and might rub on the motor is removed with the Dermal.
The motor goes back in and after checking to make sure it doesn't rub anywhere all the screws are put in and tightened up firmly
The next step it to carve out a little pocket for the lipo pack to sit in. I just trace around the pack then use the same wheel on the dremel to open it out so the lipo pac drops in neatly and doesn't move about. Just like in the next pic.
I finish up by putting the pack in there and making sure the lid will sit down nice and flush
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci