19-02-2014, 09:01 PM
Thanks Steve,
I'll go with the short shaft NTM motor I think. Apparently this model is a little tricky to dial in but flies nicely once it is. It's not meant to be a speed demon so I'm a bit wary of over powering it.
I have been caught before with this so I'm always careful to make sure I get the right one...
It is only a couple of dollars but it's kinda annoying because a couple of dollars here for a collet and a couple of dollars there for a mounting kit, soon adds up .
Anyways, I'm looking forward to beginning the build on this one. Will try even post some Pic's as I go.
Mick
I'll go with the short shaft NTM motor I think. Apparently this model is a little tricky to dial in but flies nicely once it is. It's not meant to be a speed demon so I'm a bit wary of over powering it.
Quote:Notice though, that some (all?) of the NTM Propdrive motors require you to separately order the mounting hardware and bolt-on adapter
I have been caught before with this so I'm always careful to make sure I get the right one...
It is only a couple of dollars but it's kinda annoying because a couple of dollars here for a collet and a couple of dollars there for a mounting kit, soon adds up Anyways, I'm looking forward to beginning the build on this one. Will try even post some Pic's as I go.
Mick
Spektrum DX7 Mode 2
Parkzone T28 Trojan
HK Sumo Flying Wing.... Completly Awesome!
Scratchbuilt First Step.... Slow Flyer
HK SPAD XIII....
J-Power Mini F-18 EDF
Scratchbuilt Morane Saulnier A1....Under Construction
Scratchbuilt Luton Minor.... Retired
Unbranded OV-10 Bronco.... Awaiting Build
· On the other hand, you have different fingers.