27-10-2011, 02:26 PM
I found that with Hitec servos back in the days when I used to run 4cell NiCad packs they were allways up around the 6V when freshly charged and the servo's would buzz untill the pack voltage setteled down a bit.
When you say 6V recieving pack what sort of pack is that and have you measured the voltage with a DVM? If it up around or over 6V might give you a clue as to what's going on.
Hope this helps
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci