[samste]

Hi All

I'm not an Expert in the Funjet Build but I do know some main things you may need to be aware of or Address.

1. Re Glue Mounting bracket.

# If you wish, Support mounting bracket with a plate or large washer on the underside of plane
by replacing one of the existing bolts that thread to alloy mount with a longer one that will
make to the underside.( Help in rear hard landings as well)

2. Servo mounting.

# Using the stock skyartec servos there is no issues only glue servo mount.

# Using other servos, You need to check the height of servo sitting in mount.
As you may find that servo arm will hit the top of the servo protecting covers when installed.
If this happens you may need to recess the servo mounts lower into the servo mount holes of the
plane.

3. Canopy Mount and Canopy lid.
# Re glue Canopy lid, you can spray inside of Plastic canopy lid to get the black look if preferred.

# Don't rely on button fix to hold Canopy down as it will come off in flight i Know first hand.
# use alternate methods Magnets, Velcro Etc
# I have used a pen lid pushed into the front of plane and then the cut bit of pen body and fixed to canopy front to slide into pen lid for front of canopy to lack down. The back of canopy is Velcro down.

4. Center of Gravity

# This is where you put your two fingers in the underside and check to make sure you are 10-20 %
front heavy.
This will help in Battery positioning. I have Run Velcro from front to back so i can adjust
battery position for different size and weight of lipo's.

5. Reinforcement of Body

# Carbon Rods along wings. (Strengthen wing span)

# Carbon plank front to center of gravity position. (For Hard Landings to prevent snap in half)


Steve