28-05-2011, 06:31 PM
Gday Mick
I am assuming you have this all sorted however the twinstar runs on the following set up.
Each side runs a 2650 nanotech via turnigy plush 60 to a turnigy aerodrive xp 35-36 1400kv motor. Props are 3 blade 9*7.
Kieran kindly gave her a final engineering and airworthiness look over last night and pronounced all well for the maiden.
We did decide that the power output may be overkill for the Bronco however 3 blade 8 inch props would prob fit the bill.
I have the twinstar flight ready for tomorrow, can't wait to see how she goes!
Cheers
Rob B
I am assuming you have this all sorted however the twinstar runs on the following set up.
Each side runs a 2650 nanotech via turnigy plush 60 to a turnigy aerodrive xp 35-36 1400kv motor. Props are 3 blade 9*7.
Kieran kindly gave her a final engineering and airworthiness look over last night and pronounced all well for the maiden.
We did decide that the power output may be overkill for the Bronco however 3 blade 8 inch props would prob fit the bill.
I have the twinstar flight ready for tomorrow, can't wait to see how she goes!
Cheers
Rob B