[symowallo]

Right now I'd be happy to get an easy flight mode working.
Was running late (as in early) last night, ended with the receiver (lemon satellite) and transmitter (Dx8) working. For some reason I could not get libre pilot to recognize the flightmode switch. control sticks were reading ok tough.

It did go trough the calibration setups, so I can arm / disarm and spin the motors from the transmitter. it's a start

Also It seemed I could only select DSM mode, Would like to get it to use DSMX as it should be more robust.

Still lots to explore in cc3d / libre Pilot

The trick with the flight mode is to set up the 3 way switch first in the TX before you go through the tx wizard. I'm using a 9XR Pro with ersky9x so I'm not sure how you'd do that on the Spekky. But I think you'd just designate the switch in the TX and the throw for each switch position. I use -100, 0 and +100. Then go through the tx wizard, flick the switch when it asks you.
After all that, there's a screen where you can setup the flight modes, I'll check my mancave PC and tell you what it is later on.

I have mine set to Angle/rattitude/rate. This corresponds to self levelling/horizon/acro

DSM2 vs DSMx - not sure, mine has always bound in DSMx. Check that you have it set to 2048/11ms (I think, or is it 2048/22ms) on the TX, if that can be set. Typically it'll bind at the highest it can reach.

Alternatively just bring your quad and TX to me and I can take a look at it. I'm quadding tomorrow morning I think. Possibly Sunday arvo too.