25-09-2013, 08:11 PM
Thanks for the M3 threaded bar Jason, worked a treat & ailerons now installed. I estimated 60mm, final cut was actually only 50mm. A far shot from 110mm supplied.
Needed some M3 x 10mm bolts. No luck at Hobs in Hills. Always successful at a little shop in Parra.
They are Lee Bros (also show a sign saying "the Nut House") located at 6 Dunlop St, North Parramatta. Ph 9890 1555. They stock almost any size nut, bolt or screw you could ask for. Also quite a good stock of useful tools. (I now own a tap & die set).
Few more things I need to query about this build. Rudder is a pull/pull wire system. I presume the wire crosses over each other on the way back to the rudder but have no idea where the wires exit the fuse. A photo would be handy please.
The motor standoffs needed are 65mm long, threaded to accommodate M4 threaded bolts.
No hurry for these Jason, but am hoping to have plane ready for HMAS fly in.
Needed some M3 x 10mm bolts. No luck at Hobs in Hills. Always successful at a little shop in Parra.
They are Lee Bros (also show a sign saying "the Nut House") located at 6 Dunlop St, North Parramatta. Ph 9890 1555. They stock almost any size nut, bolt or screw you could ask for. Also quite a good stock of useful tools. (I now own a tap & die set).
Few more things I need to query about this build. Rudder is a pull/pull wire system. I presume the wire crosses over each other on the way back to the rudder but have no idea where the wires exit the fuse. A photo would be handy please.
The motor standoffs needed are 65mm long, threaded to accommodate M4 threaded bolts.
No hurry for these Jason, but am hoping to have plane ready for HMAS fly in.