31-08-2013, 10:47 AM
The servos have been mounted
The wires are run along a shallow groove in the underside if the wing that is covered over with a thin strip of 3M book binding tape
The servo fairing have been trimmed to the right size but won't be glued on unroll after the test flight to make sure the linkages are right
The servos I'm going to use are
541BBs from electric wingman
Also available from HK as turnigy 541BB
The wires are run along a shallow groove in the underside if the wing that is covered over with a thin strip of 3M book binding tape
The servo fairing have been trimmed to the right size but won't be glued on unroll after the test flight to make sure the linkages are right
The servos I'm going to use are
541BBs from electric wingman
Also available from HK as turnigy 541BB
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci