Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Goldwing Edge 540T
#13

Very Nice Gazz, !!

It will fly beautifully I'm sure you'll love it !!

The only think I found with these gold wing models is you've got to put them down gently 'cause the undercarriage is a bit bendy.
I've straightened mine a couple of times after I let the vertical speed get a bit high on landing. No problem tho' they straightened out easy enough.

Good luck with the test flight tomorrow

“The knack of flying is learning how to throw your machine at the ground and miss.”

"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return."  ~Leonardo Da Vinci
Reply


Messages In This Thread
Goldwing Edge 540T - by gbanger - 11-04-2013, 10:07 PM
RE: Goldwing Edge 540T - by gbanger - 03-05-2013, 05:33 PM
RE: Goldwing Edge 540T - by wingtipper - 03-05-2013, 10:09 PM
RE: Goldwing Edge 540T - by secant0give - 03-05-2013, 10:43 PM
RE: Goldwing Edge 540T - by gbanger - 04-05-2013, 09:33 AM
RE: Goldwing Edge 540T - by wingtipper - 04-05-2013, 05:36 PM
RE: Goldwing Edge 540T - by gbanger - 11-05-2013, 05:45 PM
RE: Goldwing Edge 540T - by Steven - 11-05-2013, 06:37 PM
RE: Goldwing Edge 540T - by secant0give - 11-05-2013, 07:34 PM
RE: Goldwing Edge 540T - by wingtipper - 11-05-2013, 08:39 PM
RE: Goldwing Edge 540T - by Claudius - 11-05-2013, 10:23 PM
RE: Goldwing Edge 540T - by gbanger - 31-05-2013, 09:57 PM
RE: Goldwing Edge 540T - by secant0give - 31-05-2013, 10:02 PM
RE: Goldwing Edge 540T - by wingtipper - 31-05-2013, 10:27 PM
RE: Goldwing Edge 540T - by Flying fisho - 01-06-2013, 07:10 AM
RE: Goldwing Edge 540T - by gbanger - 03-06-2013, 10:08 PM
RE: Goldwing Edge 540T - by wingtipper - 03-06-2013, 10:41 PM
RE: Goldwing Edge 540T - by secant0give - 04-06-2013, 08:16 AM
RE: Goldwing Edge 540T - by gbanger - 04-06-2013, 05:39 PM
RE: Goldwing Edge 540T - by secant0give - 04-06-2013, 05:41 PM
RE: Goldwing Edge 540T - by wingtipper - 01-07-2013, 10:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)