03-05-2013, 10:57 AM
I havn't done much work on this for a while, mainly because I've had a couple of other distractions but I did manage to a few sets of cores from the foam I ordered a while back.
That's the good thing about having a decent jig and templates set up to cut wing cores, once the jig has been made it's a quick and easy matter to produce nice fair foam wings.
I have a couple of sets spare and a set to fit up to, a very nice light glass, lowing "Bandit" fuse I was given. It should go well with this wing!!
The 28Kg/cu meter foam is quite hard and cuts very well with the hot wire, all be it quite slowly.
That's the good thing about having a decent jig and templates set up to cut wing cores, once the jig has been made it's a quick and easy matter to produce nice fair foam wings.
I have a couple of sets spare and a set to fit up to, a very nice light glass, lowing "Bandit" fuse I was given. It should go well with this wing!!
The 28Kg/cu meter foam is quite hard and cuts very well with the hot wire, all be it quite slowly.
“The knack of flying is learning how to throw your machine at the ground and miss.”
"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return." ~Leonardo Da Vinci