Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dynam AT-6 Texan
#4

It certainly looked the part in the air today !!

How much expo were you using ?

They say that you need about 20-25% on most models to make the controll response of the model liniar. So that should be a good starting point.

Expo isn't much good unless you put the rates up a bit as well. The idea is to keep the throws around the first half of the stick movement about the same as what your used to and then it gets progressivly more for the second half.

It would take a little to get used to if you accustome to most of the controll responce comming from movent around the center of the sticks travel.

“The knack of flying is learning how to throw your machine at the ground and miss.”

"When once you have tasted flight, you will forever walk the earth with your thoughts turned skyward, for there you have been, and there you will always long to return."  ~Leonardo Da Vinci
Reply


Messages In This Thread
Dynam AT-6 Texan - by smuzz - 02-09-2012, 07:20 PM
RE: Dynam AT-6 Texan - by Skidz - 02-09-2012, 09:32 PM
RE: Dynam AT-6 Texan - by smuzz - 02-09-2012, 09:43 PM
RE: Dynam AT-6 Texan - by secant0give - 02-09-2012, 10:00 PM
RE: Dynam AT-6 Texan - by smuzz - 02-09-2012, 10:54 PM
RE: Dynam AT-6 Texan - by gbanger - 02-09-2012, 11:20 PM
RE: Dynam AT-6 Texan - by smuzz - 02-09-2012, 11:47 PM
RE: Dynam AT-6 Texan - by ConcreteTurtle - 04-09-2012, 01:12 AM
RE: Dynam AT-6 Texan - by smuzz - 04-09-2012, 09:16 AM
RE: Dynam AT-6 Texan - by dcolvey - 31-08-2013, 11:51 AM
RE: Dynam AT-6 Texan - by smuzz - 31-08-2013, 04:44 PM
RE: Dynam AT-6 Texan - by dcolvey - 01-09-2013, 06:32 AM
RE: Dynam AT-6 Texan - by smuzz - 29-09-2013, 06:38 PM
RE: Dynam AT-6 Texan - by Flying fisho - 29-09-2013, 08:35 PM
RE: Dynam AT-6 Texan - by smuzz - 29-09-2013, 09:43 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)