08-03-2010, 08:50 PM
If it were a normal Stryker, CA Hinges might be ok but for your speeds, go with 4 pivot hinges in each control surface, make sure they're really glued in well A trick I learned from Darren is cover the hinge points in oil or grease first so you don't inadvertently glue them!
Also considering the speeds, double check the foam surrounding your servo's that its not going to compress under the torque of the servo's at high speed.
Also considering the speeds, double check the foam surrounding your servo's that its not going to compress under the torque of the servo's at high speed.