29-04-2011, 06:00 PM
Servo Humm,
Installing the servo's in the Advance 25e (HS-225MG) and without horns not a sound.
Now that i have had to connect the control rods, the servo's humm!
Note that the level of the control rods is lower than the height of the horn, so i had to install the connector upside down, pain in the arse! And they also apply a little up pressure to the servo.
Is this horizontal pressure applied by the non-level rod, is what making the servo humm?
Is this bad and any suggestions on how to fix?
Installing the servo's in the Advance 25e (HS-225MG) and without horns not a sound.
Now that i have had to connect the control rods, the servo's humm!
Note that the level of the control rods is lower than the height of the horn, so i had to install the connector upside down, pain in the arse! And they also apply a little up pressure to the servo.
Is this horizontal pressure applied by the non-level rod, is what making the servo humm?
Is this bad and any suggestions on how to fix?
Dynam Pitts 12 EPO
Eflite Advance 25e
HK P-51D Mustang
3D Reaktor
Pitts Python S12 EP 54inch EPO
Kinetic 800
Decathlon EP 62.6inch
Stinger 64 EDF
Spektrum DX6i (mode 1)