26-04-2013, 01:30 PM
few questions .
#1 how do you reverse a servo without a servo reverser or tx function ?
#2 on an 8 channel receiver . if i want to use 2 channels for ailerons and 2 channels for elevons how do i do that . ?
#3 BEC / and inline switch . * ok rx battery to switch -to BEC- to rx and an aux to volt display led /or use Y lead from battery to voltage display .
#4 What about your esc i'll be using turnigy K FORCE 120V . If i connect this 12 cell setup to the esc , and the rx supply hasn't been switched on is the esc powered up ? or does it rely on a receiver signal before it starts counting cells ?
receiver ports/plug sockets , 1 throttle, 1 rudder , 2 aileron , 2 elevon , 1 bec power supply ,1 , 1 voltage reader . am i on the right track this negates all Y Leads . and uses 8 channels . with telemetry plugged into the bind port - i hope ?
or the alternative . receiver battery y lead ( 1 to voltage reader - 1 to rx supply .
aileron y lead ( to each aileron servo )
elevon y lead ( to each elevon servo ) - with one servo reversed .1 telemetry module this only uses 5 channels and 3 y leads .
thanks in advance .
i bought an inline sliding switch from JAYCAR , for $2 seem to be a little better quality and bigger more heavy duty than the HK ones , just have to solder it up to battery and receiver leads .
#1 how do you reverse a servo without a servo reverser or tx function ?
#2 on an 8 channel receiver . if i want to use 2 channels for ailerons and 2 channels for elevons how do i do that . ?
#3 BEC / and inline switch . * ok rx battery to switch -to BEC- to rx and an aux to volt display led /or use Y lead from battery to voltage display .
#4 What about your esc i'll be using turnigy K FORCE 120V . If i connect this 12 cell setup to the esc , and the rx supply hasn't been switched on is the esc powered up ? or does it rely on a receiver signal before it starts counting cells ?
receiver ports/plug sockets , 1 throttle, 1 rudder , 2 aileron , 2 elevon , 1 bec power supply ,1 , 1 voltage reader . am i on the right track this negates all Y Leads . and uses 8 channels . with telemetry plugged into the bind port - i hope ?
or the alternative . receiver battery y lead ( 1 to voltage reader - 1 to rx supply .
aileron y lead ( to each aileron servo )
elevon y lead ( to each elevon servo ) - with one servo reversed .1 telemetry module this only uses 5 channels and 3 y leads .
thanks in advance .
i bought an inline sliding switch from JAYCAR , for $2 seem to be a little better quality and bigger more heavy duty than the HK ones , just have to solder it up to battery and receiver leads .
patience !! paaatience !! paaaaaatience paaaaaaatieeence dooooohhhh !!!
DANGER WIFE CAN READ FORUMS . love you darling . sig changed .